For bonding moldings, ceiling tiles, wall underlays and decorative rosettes made of polystyrene or polyurethane.
Supports:
- Porous substrates, such as brick, concrete, plaster and wood.
- Condition: Clean, dry, degreased.
- Surface preparation: Apply a primer coat beforehand on highly porous surfaces. It is advisable to perform an adhesion test on all surfaces.
Application:
- Using a comb, apply the adhesive to the surface, ensuring it can be covered within 15 minutes. Apply the adhesive to the molding.
- Position the molding and then press it down. Heavy or tense materials must be clamped or supported.
- The glued material can be used after approximately 24-48 hours.
- Application temperature: +5 °C to +35 °C
- Cleaning product: Before drying, use water; after drying, use only mechanically.
Technical specifications:
- Measured at 20°C / 65% (relative humidity).
- These values may vary depending on environmental factors such as temperature, humidity and the nature of the substrate.
Synthetic Dispersion Material
Pasty consistency
White
Physical Polymerization Curing System
Opening time ± 15 to 20 minutes
Drying time ± 24 hours
